RS Sailing Parts

A twin tube mast Flotationbag. It slides up and down the mast at the same time as the mainsail, which makes it a very tidy and unobtrusive design. Helps prevent a full inversion. Total capacity 8 liters. Only works on boats with a mainsail mast track...

Large parallel stainless steel spring. Suitable for 40-80mm blocks including ratchet blocks.

Inspection Cap used on the RS Tera and RS Quba. Used near helm between the hiking strap attachment crosses.

Selden 4 Inch/100mm Hatch, used on the RS CAT16, RS Quest, and RS Neo. Attach with 8x screws, whose part number is FIX-S8-P02.   Cut out diameter: 112.5mm (4.43 inches).

25mm Hiking Strap Attachment Plate used on the RS Quest. Attach using 2x screws, whose part number is FIX-B5-C12. Also used on the RS Neo, RS Aero, and RS Zest.

Hiking Strap Attachment Cross used to secure the hiking strap on the RS Tera. Attach using 1x screw, whose part number is FIX-B6-C20.

Gudgeon, plastic with lock. Used on the RS Cat 16 near the console and on the RS Quest transom. Attach using two screws, whose part number is FIX-S10-P01.

Grub screw used on the RS Quest Mast Heel Plug & the RS Aero Gooseneck.

The shaft that attaches the booms inboard end to the stainless toggle on the RS Quest. As used on the RS Vision and RS500. Specifications: 6 x 32mm with 2 grooves.

Boom Inboard End/Gooseneck fitting for the RS Feva and RS Zest. Comes with rivets needed to install it.

Used with Selden GNAV Boom Slider with Sheaves. Also used for attaching the boom. Used on RS Vision and RS500.

Selden GNAV End Fitting.Used on the RS Vision and RS500.

Selden Furler Top Swivel with Guide. Used on the RS Venture and RS Vision as part of the jib roller furling system. Uses a 5mm x 18mm clevis pin.  

Bullseye fairlead used on the RS Aero. This fairlead is used twice on the bow in both respects. Attach using 2x screws, whose part number is FIX-S10-P15.

Bullseye fairlead from Selden. Length: 40mm. Width: 15mm. Height: 22mm. MaxLineSize: 10 mm. Hole Spacing C-C: 25 mm. Fasteners: 2x M5 screws.

Front carrying handle used on the RS Tera, and RS Quba. Attach using two screws and two saddles. Part numbers for the screws and saddles are FIX-B6-P12 and 52799, respectively.