Mast & Boom

The Tasar gooseneck fits to the mast and includes both the boom pintle and rotator handle bracket. Steel construction Electro-polish finish Pre-drilled rivet holes Pin Diameter: 7.85mm (0.3") If this item is out of stock, please contact our team...

Stiffens the upper section of the mast. Custom aluminum 2 piece fitting.

The Tasar Mast Base Plug fits the lower mast section and allows the mast to rotate on the Mast Step Plate. The diamond adjuster screws are recessed and the step plate pin hole is elevated 4.5mm to prevent the mast from catching. Snug fit with inner...

An insert located and supported by the upper diamond bolt and having the same cross section as the top mast sleeve.

Tasar Main Halyard Upper Sheave. Solid Acetyl construction High load Fits with sheave axle Diameter: 50mm Width: 8mm Bore: 9mm Weight: 10g

The Tasar Boom Bail is used at the vang and mainsheet. Made of Stainless Steel

The fine tune stay adjuster provides for a quick and easy way to adjust stay tensions. It greatly reduces the risk of losing the stay when adjusting rig tension. 316 stainless steel Pin - 3/16 inch Increment Length - 5/32 in. Qty. Adjustment Settings -...

The Tasar Vang Tang mounts to the bottom of the lower mast section and accommodates two mounting locations for the vang blocks. Made of Stainless Steel Width: 44.5mm (1.75") Height: 38mm (1.5") Upper Tang Width: 19mm (.75") Lower Tang Width: 22mm (...

The axle for Tasar main halyard sheave mounts to the mast and provides low friction for the halyard sheave. Aluminum construction Includes Stainless screws Length: 30mm (1.-1/5") Diameter: 8mm (1/3") Weight: 2g

Tasar Forestay, 3/32" 1x19 SS wire, Includes 2 Sailors Thimble and 2 Nicro Press Sleeves.  West Coast Sailing Rig ShopThis item is hand built by our Rig Shop using industry leading best practices for splicing and rigging so you can be confident in...

The Tasar Whisker Pole Eyestrap mounts to the mast end of the boom and holds the whisker pole in place when not in use. Made of Stainless Steel Stamped shape mounts flush to boom Height: 1" Distance between rivet holes: 2-3/8" Fastener Size: #10

The Tasar Rotator Stop attaches to the boom and holds the rotator handle from over rotating the mast. This rotator stop will fit the standard Tasar boom profile. Machined from hi-grade aluminum Bright red color, hard marine anodized Pre-drilled rivet...

Complete Tasar Lower Mast. All fittings, black aluminum. If this item is out of stock, please contact our team for a lead time estimate. Freight Shipping Information This item is classified as FREIGHT due to weight and/or length and is therefore not...

The Tasar Spreader is made of sleeved aluminum and includes slotted Delrin ends for the shrouds. The spreader comes complete with everything needed to replace an old or bent spreader. Delrin end fittings Stainless steel washers and cotter pins

The Tasar Lower Halyard Clip holds the free halyard to the mast after locking into the halyard lock. Plastic Construction Length: 57mm Height: 18mm Rivet Hole Size: 4mm Distance Between Rivet Holes: 43mm If this item is out of stock, please...

This key pin style shackle is made form stamped stainless steel, with a 3/6 inch pin and 1-7/16 inch length. Simply twist the pin a quarter turn to secure. One Design Applications Tasar Bow Shackle (x1)