General Parts

Size-for-size in our expanding range, Harken Zircon blocks are the most efficient small boat blocks Harken has ever made. At the core of Zircon performance are industrial ceramic ball bearings mounted inside caged races. The cages keep these bearings...

Size-for-size in our expanding range, Harken Zircon blocks are the most efficient small boat blocks Harken has ever made. At the core of Zircon performance are industrial ceramic ball bearings mounted inside caged races. The cages keep these bearings...

Lightweight, low-friction wire blocks carry wire halyards and high-strength control lines on boats of all sizes. The Harken 466 features a forkhead and becket making it useful for vangs, halyards and control lines. Sheave Ø - 25 mm / 1...

These robust low-friction ball bearing handles match a wide range of cranking needs for both racers and cruisers. Ball bearing grip that efficiently transmits power into the winch. All handles fit international standard winch sockets.

Track is extruded from high-grade 6061-T6 aluminum and hardcoat-anodized for a hard, long-lasting surface. 3807 track mounts to mast using a unique slug system that allows mast-up installation. ONE DESIGN APPLICATIONS This fitting is commonly used and/or...

Harken Small Boat furling systems allow the trailerable cruising or dinghy sailor to set and furl the jib from the cockpit. An optional hoistable ball bearing halyard swivel can be installed on your headstay so you can raise or lower the sail without...

This is a standard bow shackle used commonly on the 420, FJ & V15 and as a mast bail on 3:1 purchase 420 vangs. It is an excellent shackle for all-around use with screw pin included. HAR 2110 1/4 inch / 6mm diameter screw pin for easy...

Use the 237 and 339 where there is little deflection in the line such as when routing a spinnaker pole foreguy aft along the cabin house. Use with Harken 241 cam base. A (mm)32 mm A (in)1 1/4 in B (mm)38 mm B (in)1 1/2 in Fasteners (mm)5 RH...

Stamped shackles are used on most small boat blocks and are appropriate for low loads. This shackle has a 6 mm / 1/4 inch pin with a ring for easy attachment. For higher loads, select forged and high-resistance shackles instead. Shackle pin: (mm)6...

The makers of McLube Lubricants have added a Teflon finished, citrus based hull polish for dinghies! 16oz bottle Made by McLube

The Harken Swivel Cam Cleat is a simple swivel base for main and jib sheets on small sailboats. Includes a swivel base, bullseye fairlead, and standard Harken cam cleat. The base rotates 360 degrees making it easy to cleat and un-cleat from any angle...

29mm Bullet Block Single with Swivel from Harken. 29mm Single Swivel Block

Wire fairleads maintain a low profile while holding the line close to the cleat.. Height (mm)32 mm Height (in)1 1/4 in Length (mm)65 mm Length (in)2 9/16 in Width (mm)32 mm Width (in)1 1/4 in Weight (g)14 g Weight (oz)0.5 oz Fastener spacing (mm)38 mm...

29mm 90 Degree Traveler Blocks from Harken. 29mm Two single blocks at 90 angle for use with traveler applications Made by Harken

Harken cam cleats utilize a system of multiple rows of ballbearings allowing the line to be cleated by snapping down rather than drawing through. The cams are design to provide maximum holding power without destroying the line. This includes smooth...

Large stainless eyestrap from Harken. ONE DESIGN APPLICATIONS This fitting is commonly used and/or recommended for the following one design sailboat applications: J/22 Traveler Block Eyestrap (x2)