RS Sailing Parts

Clew Strap for the RS Feva.

Mainsail stainless steel clew loop for the RS Feva.

38mm Eyestrap used for the RS Feva Jib Sheet. Made by Allen Brothers. Used with A676 cam cleat.

38mm Cam Cleat used for the RS Feva Jib Sheet. Made by Allen Brothers. Works for 4-10mm line diameters. Maximum working load 286lbs.

28mm Ball Bearing Cam Cleat. Used for the RS Feva Spinnaker Halyard. Made by Allen Brothers. Works for 2-6mm line diameters. Maximum working load 220 lbs.

Inbound end cap for the RS Feva Bow Sprit. Made of plastic, pushes in, and fits a 38mm tube. Also used on RS Vareo Bowsprit.

Complete Bow Sprit for the RS Feva. Fully rigged including control lines and end caps.

Forged Bow Shackle with 5mm pin by Allen Brothers. Used on the RS Feva.

Complete Boom for the RS Feva. Includes all fixed hardware attached to the boom. Oversize Shipping Information This item is considered oversize due to length and/or weight and not eligible for standard shipping. Oversize ground shipping is available to...

Complete batten set for the RS Feva Mainsail. Set of three battens (two short, one long) with batten tips/caps.

The bottom furler for the RS Cat16. Attaches to the Spinnaker Chute 'Boomerang.'

Clip to attach the Little Hawk Wind Indicator. Attaches to the RS Aero upper mast just below the mast plug using two screws, whose part number is FIX-S8-C03. Also used on the RS Neo.

Little Hawk Wind Indicator for the RS Aero. Mounts to the mast using the wind indicator clip, whose part number is AER-UA-108.

Swivel cleat for the RS Aero Vang. Mounts on top of the mounting base, whose part number is AER-HF-403.

Mounting Base for the RS Aero Vang. Use two screws, part number FIX-S10-P15, to set into the round aperture just forward of the daggerboard case. The vang swivel, part number AER-HF-402, mounts on top of this base.

Top Plug for the RS Aero Top Section. Also used on the RS Neo.