RS Sailing Parts

Scupper Flaps for the RS Venture. Allows water to drain out of the cockpit.

Traveler block for the RS Tera. This is a Plain Bearing 38mm Single Block with an inglefield clip. Maximum line size: 10mm. Maximum working load: 341 lbs.

Padded Hiking Strap for the RS Tera. This is the standard hiking strap which comes with the boat.

Selden Spreader Length Adjuster. Used on RS100, RS200, RS400, RS500, RS800, and RS2000.

Shroud Lever used on the RS Quest. Used as the lowest portion of the forestay assembly. Length: 280mm.

An eyebolt that passes through the hull (at the gunwale) and into the Under Gunwhale Recess Bar on the RS Quest. The eyebolt provides the attachment point for the shroud adjusters. The part number for the recess bar is C16-HF-900.

27mm Cam Cleat by Selden. Used on the RS Quest to secure the spinnaker sheet, and spinnaker halyard, among other applications.

Reefing hook used to secure the tack of the RS Quest Mainsail. Used in reefing the mainsail. Attaches to the gooseneck whose part number is 509-081-01.

Mast Foot/Plug for the RS Quest. Includes upgraded pivot pin. Connects the bottom of the RS Quest mast to the mast step, whose part number is QUE-HF-200.

Pivot Pin for the RS Quest Mast Step. Use with RS Quest Mast Plug/Foot, whose part number is QUE-SP-904.

Mast Step for the RS Quest. Attaches to the Beam Assembly using 2x rivets. The part numbers for the Beam Assembly and rivets are QUE-HF-105 and FIX-R64-M18, respectively.

Kit for upgrading the RS Quest Mainsheet Base to a Swivel Base with cam cleat. The kit includes the 4x screws and cable ties needed to install the upgrade. This kit can also be used on the RS Toura. Instructions for installation

Handles which attach to the leading edge of the chines on the under (water) side of the RS Quest hull and RS Zest Hull. Attach using 2x screws whose part number is FIX-B5-C20. Can be used to help lift the boat when it is upside down. Also provide a wear...

Center Hatch for the RS Quest Foredeck. Requires O-Ring and 8x screws to install. The part numbers for the o-ring and screws are A.638 and FIX-S8-P02, respectively.

Transom drain assembly for the RS Quest. Flap allows water to freely drain out the transom.

Rubbing plate/gasket retainer for the RS Quest and RS Zest centerboard case. Used on the under (water) side of the RS Quest centerboard case to secure the centerboard gasket. Helps to stabilize the daggerboard. Secured outward of the centerboard gasket...