ISCA / Sunfish Parts

The Harken Swivel Cam Cleat is a simple swivel base for main and jib sheets on small sailboats. Includes a swivel base, bullseye fairlead, and standard Harken cam cleat. The base rotates 360 degrees making it easy to cleat and un-cleat from any angle...

Sunfish rudder blade. Mates to the rudder head. Class legal Fiberglass Reinforced Plastic

Lower outhaul line for your Sunfish boom. Ties end of sail to cap on end of boom. Line: 4mm Robline Sirius Length: 3 Feet

Upgrade your Sunfish mainsheet with this handy pre cut mainsheet line, cut to our recommended length of 25 feet for a durable and long lasting 8mm line that has a great feel and works well in mainsheet blocks. Line: 8mm Robline Orion Length: 25 Feet

Standard drain plug fitting from Beckson. Complete assembly with screw-in plug and housing, with 1 inch plug hole diameter and 1.5 inch mounting hole spacing for drain plug housing. Plastic keeper helps prevent the plug from falling out of the housing...

These rubber "O" rings are part of the Sunfish Bailer, placed between the hull and the bailer housing to create a nice seal. Available in a 5 pack so you'll have spares. Pack of 5 rubber rings Class legal for the Sunfish Fits both the 1-5/16 and 13/16...

Hiking strap retainer line for the Sunfish, designed to secure your hiking strap to the rear of the cockpit. Line: 5mm Robline Sirius 500 line Length: 3 feet (Quantity 1 = 3 foot length) Typically cut from black/silver spool, but exact color may vary ...

The Tiller Joint Universal connects a tiller extension with a tiller. The flexible rubber allows for a full range of motion with the tiller extension. New tiller extensions come with a joint universal, so you can use this one to replace one that has...

Use these fabric tell tales to ensure correct sail trim. Made from rip stop fabric for durability. Adhesive patches are included for installation on your sail. 3 Green 3 Red Fabric tell tales

This Sunfish cover is a cross between a flat cover and our mast up cover. This cover has the tail on the cover to allow the spars and sail to be stored on deck. It will also be cut wider to make room for the spars on deck. This cover has a large...

The Sunfish Bow Bumper is a simple accessory to keep this vulnerable part of the boat protected from common scratches and dings. It is molded with a high-grade rubber compound so you can be sure it is tough and long lasting. It is a two-piece set,...

The Sunfish top cover will enclose your Sunfish deck, protecting the topsides from the elements. It fits snugly below the rub rail of the hull to seal out dirt and water. The cover installs securely with an elastic cord and webbing loop tie down points...

This is the bronze Sunfish snap trigger. Tie the end of the mainsheet to this and then snap it onto the traveler. Bronze fitting. Use at end of Sunfish mainsheet for convenient attachment to traveler bridle.

The horn cleat is perfect for tying off halyards securely. Used on a variety of small sailboats, including the Sunfish for securing the main halyard. 3-3/4 inch length. Black anodized aluminum. Commonly found on Sunfish deck for main halyard cleating.

Made from a lightweight yarn, these telltales are great to help with correct sail trim. Includes adhesive patches for installation on your sails. 100% wool yarn Adhesive application discs Resists hang ups and sticking 8" long Includes 7 Green and...

This mast up, mooring style Sunfish Deck Cover fits snugly below the rub rail of the hull to seal out dirt and water. This cover is installed with the mast up and the spars and sail down. This cover is held on by an elastic cord in the hem of the cover;...