Jib halyard line for the J/80 sailboat from the West Coast Sailing Rig Shop. This option is made from Marlow D2 Racing, a pre-stretched, bio-based double braid line that is a great high-strength and...

Furling line for the J/80 sailboat from the West Coast Sailing Rig Shop, featuring New England Ropes Sta-Set with whips on each end for a clean finish. Sta-Set is a great double braid polyester line...

Replacement rudder pin for Hobie Passport 10.5 and Passport 12 kayaks.

Rudder pivot assembly for Hobie Passport 10.5 and Passport 12 kayaks. Hobie Part Number 77800035

Make life easier for your bow person with our J/24 Topping Lift/Foreguy strop. Use this dyneema strop to connect your Topping Lift and Foreguy hooks, making it easier to get your spinnaker pole set...

One piece headstay wire for the Thistle sailboat made from 1x19 stainless wire with stainless fittings. Also known as the NWOD (Northwest One Design) style as found in boats built in Portland, Oregon...

Stainless steel shroud wire for the Thistle sailboat. This shroud uses 1x19 stainless wire with an Aircraft Eye on one end and a Marine Eye on the other, designed to connect directly via the fork to...

The Laser / ILCA Vang Upper Block is a Harken wire block with becket with attached vang key. It features indented sides to prevent the line from slipping off the sheave. The included vang key is the...

Padded hiking strap for FJ sailboats. Use two of these 28 inch straps in the AFT position of the FJ for the skipper. Sold individually. Padded hiking strap 28 inch length Sold individually 

Padded hiking strap for FJ sailboats. Use two of these 36 inch straps in the FORWARD position of the FJ for the crew. Sold individually. Padded hiking strap 36 inch length Sold individually 

16cm long sticker for the halyard and outhaul. Use this red version for club, silver, and quicksilver spar sets.

This sticker acts as a guide, allowing you to hoist and trim the sail to the proper level on an Optimist sailboat. Use Blue for Silver / Quicksilver Optimist masts Measures position of sail...

Complete FJ jib halyard assembly. Made from 3/32 inch wire with becket block nico pressed on one and and a snap shackle on the other. Halyard tail is 4mm line with Dyneema core for very low stretch...

Replacement traveler block for ILCA sailboats. The small size traveler block connects to the large size trabeler block with integrated sister clips. This is the 'traveler' side of the set up. Pass...

Replacement traveler block for ILCA sailboats. The large size traveler block connects to the small size traveler block with integrated sister clips. This is the 'mainsheet side' of the traveler set...

The hiking strap plate is a small, flat plastic plate that is mounted over your hiking strap. Installed just forward of the cockpit wall and behind the mainsheet eyestrap. Can be used on any Laser...