Forestay wire for Club 420 sailboats from Zim and Laser Performance. This stainless steel forestay supports the mast from the bow. 3/32 inch diameter Approximately 14 foot 6 inches long Fits Club 420 sailboats from Zim and LaserPerformance Zim Part...

6mm shockcord with PVC handle to retain the daggerboard in the trunk. Keeps your hiking strap up too. Comes in a complete set with 2 sizes of tubing, shockcord and 3 mm Vectran rope to keep the shockcord in place. Includes instructions. 6mm...

This safety shackle is made from stainless steel and can be easily released with one hand. Stainless steel construction Easy one handed use

This is the C420 centerboard gasket material for use on newer C420s with recessed gaskets. Slightly wider than original material. One piece only. Durable mylar plastic material Single gasket piece only 1.5" wide Zim Part # 20358 / Laser Performance Part...

The Tasar Mast Step Plate mounts to the deck of the Tasar and allows the mast to rotate. This new design step fits most older screw patterns and fits all mast step plugs. The pin is machined from solid stainless steel to prevent pin failure. Machined...

Sunfish Blade Bag with separate padded and lined compartments for both the rudder and daggerboard. The large mesh pocket is perfect for holding additional parts and gear. Treat your blades right. The Colie Deluxe Blade Bag has separate padded and...

The halyard connector is use as a tail for the 29er jib and main halyard spectra sections. This line it pre cut to our recommended length for easy rigging and a great fit. Line: 4mm Robline Sirius Length: 33 feet.

This Opti boom end plug fits the aft end of the boom and accepts the outhaul line. The cap fits any 32mm standard opti boom. Fits any Opti boom with an interior diameter of 32mm Seals the boom from water intrusion

The Sunfish Bow Bumper is a simple accessory to keep this vulnerable part of the boat protected from common scratches and dings. It is molded with a high-grade rubber compound so you can be sure it is tough and long lasting. It is a two-piece set,...

C420 hiking strap, black webbing with a pad underneath for comfort when hiking hard. This strap has center webbing loops to tie on to the traveller bar. Sold as single straps, add 2 to cart for a pair. Full length strap - crew and skipper Fully padded...

Keep your boat afloat! This is the standard and best selling Opti bailer in Green with attached lanyard. Large green bailer Lanyard provided Recommended for Opti sailors

Anodized black ClamCleat for BlackGold sprit adjusters on Opit sailboats. Small notch at end to pass line through.

Low-friction Micro blocks are compact and lightweight. They are ideal for sailboards, smaller dinghies, and lightly loaded control lines on boats of all sizes. Sheave: 22 mm / 7/8 in Length: 102 mm / 4 in Weight: 57 g / 2 oz Shackle pin: 5 mm / 3/16 in...

Centerboard for the 420 Original Equipment Zim Part # 20102 / Laser Performance Part # 85000 Compatible with both Zim and Laser Performance boats

Deck control line for 29er cunningham pre cut to 13 feet from a super low stretch 4mm Excel Racing line. Line: 4mm Excel Racing Line Length: 13 feet

The Traveler Bushing allows the traveler block strop to pass through the thwart. Acetyl construction Mounts to thwart Inside Diameter: 15mm Outside Diameter 25mm Screw Hole Size: 3mm Distane between Screw Hole: 36mm