The 30mm Extreme High Load Vang Block from Allen Brothers (Part Number A2031XHL-873) is a new Laser / ILCA specific vang block featuring a 30mm Extreme High Load Block (XHL) with removable vang key. The block features the same extreme high...

The boom block with becket is attached to the aft end of the ILCA boom. Pass your mainsheet through the block, down to the traveler block, and back up to secure to the becket. A great upgrade for an older boat, particularly for light air sailing!...

The standard boom block is mounted to the mid point of the ILCA boom. Pass your mainsheet up from your mainsheet block, through the boom block, and then aft to the boom block with becket to complete your rigging. Attaches to the boom with the stainless...

Integrated large and small ILCA traveler block from Allen with ball bearings for great performance. Replaces the standard 'traveler block large' and 'traveler block small' which are connected with a sister clip to reduce the space between the blocks and...

30mm Single High Load Dynamic Block With Fork Head. High load blocks feature a stainless-steel sheave. This upgrade offers even faster rolling speeds, higher working loads and lower friction when compared to the standard acetal sheave. The...

The new Harken Power3 ratchet blocks provide sailors that race small one-designs with three holding-power options to handle a variety of wind and sea conditions. More choices allow sailors to fine-tune their set-ups in tandem with the purchase that...

A low-friction Harken 29mm Carbo AirBlocks from Harken. A lightweight, strong, reliable and affordable block. This variation comes with a removable bolt through the middle so it can be undone and connected to various locations on your boat...

Keep your Laser / ILCA Harken Vang Base in top condition by replacing your worn out fairlead. Modern control lines with Technora and other high strength fibers can wear the edges of your fairlead, leading to premature wear on your control line. Flipping...

The Laser / ILCA Vang Upper Block is a Harken wire block with becket with attached vang key. It features indented sides to prevent the line from slipping off the sheave. The included vang key is the latest 'updated' style with larger head for...

When end controls are not used, add endstops to absorb shock loads. ONE DESIGN APPLICATIONS This fitting is commonly used and/or recommended for the following one design sailboat applications: Thistle Traveller Track Endstops (x1)

When end controls are not used, add endstops to absorb shock loads. ONE DESIGN APPLICATIONS This fitting is commonly used and/or recommended for the following one design sailboat applications: Sonar Main Traveler Track Endstops (x1)

Endstops absorb shock loads. Use the built-in groove to deadend 2:1 control line. Sold in pairs. Fasteners not included.

Track is extruded from high-grade 6061-T6 aluminum and hardcoat-anodized for a hard, long-lasting surface. 3807 track mounts to mast using a unique slug system that allows mast-up installation. ONE DESIGN APPLICATIONS This fitting is commonly used and/or...

The X-Treme Angle Fairlead allows releasing and recleating at angles up to 90 degrees to the cleat. Kit includes hardcoat-anodized 150 aluminum Cam-Matic and 375 X-Treme Angle Fairlead.

Ball bearing swivel bases feature dual rows of Delrin ball bearings that swivel freely even under high loads. Bases include stand-up springs and a U-adaptor to accept a variety of appropriate blocks. ONE DESIGN APPLICATIONS This fitting is commonly used...

Wire fairleads maintain a low profile while holding the line close to the cleat. Kit includes lightweight, fiber-reinforced 471 Carbo Cam, and 475 wire fairlead. ONE DESIGN APPLICATIONS This fitting is commonly used and/or recommended for the following...