General Parts

The all new injection molded fiberglass nylon winch handle is made by way of air assist injection molding instead of foam filled method, thus preventing any potential leakage of foam from within the handle. Both sizes feature ball bearings in the handle...

Bring your sailing experience to a new level! Davis Instruments introduces Blacksmith Wind Vanes, made from super lightweight 3D carbon fiber and duraluminum to withstand the rigors of hard racing. This a dinghy race pro gooseneck wind vane for Laser,...

The Great Hawk is a scaled up version of the original Hawk. It is designed for cruising and racing yachts up to 20m. The vane and arms are made of super tough, glass-filled Nylon 12, for improved rigidity, durability, and UV resistance over similar...

Track is extruded from high-grade 6061-T6 aluminum and hardcoat-anodized for a hard, long-lasting surface. 3807 track mounts to mast using a unique slug system that allows mast-up installation. ONE DESIGN APPLICATIONS This fitting is commonly used and/or...

Harken Small Boat furling systems allow the trailerable cruising or dinghy sailor to set and furl the jib from the cockpit. An optional hoistable ball bearing halyard swivel can be installed on your headstay so you can raise or lower the sail without...

This cam cleat saddle is used to keep the uncleated line within close proximity to the cleat, facilitating recleating. Made from grade 316 stainless steel and suitable for large Ronstan T-Cleat and C-Cleat cam cleats. Grade 316 stainless steel Weight -...

This Ronstan cam cleat fairlead is easily fitted to existing T-Cleat and C-Cleat cam cleats. Allows precise cleating and release from any lead angle with lower entry efforts for off-centre cleating. Made from a tough, abrasion resistant composite...

The Ronstan C-Cleat large cam cleat is the product of intensive development efforts, producing a range of cleats that provide unbeatable holding power, yet are designed for easy cleating and releasing of control lines in every application and load...

Replacement drain plug from Ronstan. This is the PLUG ONLY - No plastic housing included. See Ronstan 30mm Bow Drain Plug for plug + housing.   Which drain plug do I need? When replacing an existing drain plug, it can be difficult to know...

Rooster 2mm Pull Fid for splicing modern ropes.

A balanced and lightweight tool that enables faster and easier rope splicing. Simple to use Lightweight design Balanced construction 2 needles supplied Suitable for use on ropes up to 5mm

A twin tube mast Flotationbag. It slides up and down the mast at the same time as the mainsail, which makes it a very tidy and unobtrusive design. Helps prevent a full inversion. Total capacity 8 liters. Only works on boats with a mainsail mast track...

Swivel cleat bases permit easy cleating and releasing from any angle. Dead eyes contain stainless steel liners for low friction and long life. Cleating plates are heavy gauge alloy for stiffness and minimum distortion under load. Great for sheet leads...

Intensive development efforts have produced this range of cleats that provide unbeatable holding power, yet are designed for easy cleating and releasing of control lines in every application and load condition. Through the use of advanced composites,...

The Ronstan 15 mm Utility Block range offers small boat sailors a lightweight, stainless steel block range for a variety of applications such as control lines and shockcord tension systems. This is the basic loop head type single block, great for lashing...

This plastic cleat is suitable for low-load uses. A simple and economical cleat. Total Length: 3 1/4" Hole Center to Hole Center: 2 5/8" Width:  11/16" Fits Ropes 1/8" - 1/4" Durable Nylon construction Mounts easily to flat or rounded surfaces